Micronutrients’ Role

  • 1
  • March 06, 2017

Of the essential nutrients plants must have to grow, eight are referred to as micronutrients. While plants use micronutrients in very small amounts, they are just as essential for plant growth as primary (N, P, and K) and secondary (S, Ca, and Mg) nutrients. Any one of them can limit growth and even cause plant death when deficient.

Micronutrient deficiencies can be difficult to recognize because they resemble other problems. For instance in corn, manganese deficiency produces yellowing, which can look like a sulfur deficiency or even be confused with nitrogen deficiency. Often tissue testing can determine the cause, but it is best to have a good soil test so any problems can be addressed ahead of seeing nutrient deficiency symptoms.

Why are micronutrient deficiencies increasingly being seen in the soil:

  • Increased yields due to various technologies means higher removal of micronutrients from the soil.
  • Some micronutrients are no longer contained in high analysis fertilizers and fertilizer materials.
  • Any type of land preparation which results in the removal of several inches of topsoil can result in a deficiency of certain micronutrients on the cut areas.
  • High phosphorus levels can induce micronutrient deficiencies.

(Midwest Laboratories Agronomy Handbook)

Micro 500™ is a precision balanced combination of five essential micronutrients: zinc, manganese, iron, copper and boron. Utilizing Flavonol Polymer Technology, Micro 500™ provides the benefit of a synergistic combination of micronutrients, and should be considered when a specific micronutrient deficiency has not been established. Each crop grown has minimum requirements of certain micronutrients in specific proportion to each other. The formulation of Micro 500™ is designed to fill those requirements and should be used in most cropping programs. These nutrients are synergistic. Growers get better uptake and response from a micronutrient in Micro 500 than if they apply an equal volume of a nutrient alone. In addition, having this combination available is helpful in pockets of a field where a grower might be unaware that a particular nutrient is lacking. Trials show that AgroLiquid micronutrients perform better than dry micros because applicators can place them in a root zone band (in furrow or near the seed). Micro 500 also offer better results compared with other conventional EDTA-chelated micronutrients.

Check out AgroLiquid’s MicroLink family of products for all of your micronutrient needs. Do you have questions? Contact an AgroLiquid representative today!

Leave a comment

Your email address will not be published. Required fields are marked.